TM 10-7360-201-10
2-8. ASSSEMBLY AND PREPARATION FOR USE-- Continued
(p) Loosen wingnuts (11) on clamp that
secures blower motor to storage
compartment, and slide blower motor
out of compartment.
(q) Slide blower motor(12) and mounting
plate on motor pivot shaft of oven.
(r)
Insert head of bolt (13) on blower
motor takeup arm into mounting
bracket slot.
(s)
Place V-belt (14) on motor pulley and
blower shaft pulley.
(t)
Tighten wingnut on bolt on takeup
arm (15). (u) Check oil level (16).
(3) Proofing cabinet.
(a) Before locating the proofing
cabinet, wash inside and outside
of cabinet with soap and warm
water. Rinse thoroughly and dry
cabinet with clean cloths.
(b) Set the cabinet in the desired
location and be sure cabinet is
level.
(c) Clean the four water pans and
place them on the heater racks
(1).
(d) Uncoil power input cable (2).
PROOF CABINET
2-35