TM 10-7360-201-24P
e. INDEX NUMBERS. Items which have the word BULK in the figure column will have an index number shown in
the item number column. This index number is a cross-reference between the National Stock Number/Part Number
Index and the bulk material list in Section II.
f. ASSOCIATED PUBLICATIONS. The publications listed below pertains to the Bakery Plant and its components:
Publication
Short Title
TM 10-7360-201-10
Operator
TM 10-7360-201-20
Organizational Maintenance
TM 10-7360-201-35
Field and Depot Maintenance Manual
TM 10-7360-201-24P
Organizational Direct Support and General
Support Maintenance Repair Parts and
Special Tools List
6. HOW TO LOCATE REPAIR PARTS.
a. When National Stock Number or Part Number Is NOT known.
(1) First. Using the table of contents, determine the assembly group or subassembly group to which the item
belongs. This is necessary since figures are prepared for assembly groups and subassembly groups, and
listings are divided into the same groups.
(2) Second. Find the figure covering the assembly group or subassembly group to which the item belongs.
(3) Third. Identify the item on the figure and note the item number.
(4) Fourth. Refer to the Repair Parts List for the figure to find the part number for the item number noted on the
figure.
(5) Fifth. Refer to the Part Number Index to find the NSN, if assigned.
b. When National Stock Number or Part Number Is Known:
(1) First. Using the Index of National Stock Numbers and Part Numbers, find the pertinent National Stock
Number or Part Number. The NSN index is in National Item Identification Number (NIIN) sequence (see c-4a.(1)). The
part numbers in the Part Number index are listed in ascending alphanumeric sequence (see paragraph c-4.b). Both
indexes cross-reference you to the illustration figure and item number of the item you are looking for.
(2) Second. After finding the figure and item number, verify that the item is the one you are looking for, then
locate the item number in the repair parts list for the figure.
7. ABBREVIATIONS. Abbreviations used in this manual are listed in MIL-STD-12.
Abbreviations
Explanation
Abbreviations
Explanation
ADJ
Adjusting
PL
Plate
DISCHG
Discharge
RT
Right
8