ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
S e c t i o n I . G E N E R AL
This chapter contains the removal, cleaning, inspection, and installation procedures for Organizational
Before maintenance always keep in mind the WARNINGS and CAUTIONS
located on the inside front cover.
Section II. REPAIR PARTS, SPECIAL TOOLS, AND SUPPORT EQUIPMENT
4-2. COMMON TOOLS AND EQUIPMENT.
For authorized common tools and equipment refer to the Modified Table of Organization and Equipment
(TMOE) applicable to your unit.
4-3. SPECIAL TOOL AND SUPPORT EQUIPMENT.
A special tool is required to remove and adjust the burner valves. Refer to Appendix B, Section III for
description and tool number. There is no special support equipment required for maintenance of the field
4-4. REPAIR PARTS.
Repair parts are listed and illustrated in Appendix C of this manual.
Section III. SERVICE UPON RECEIPT
Refer to paragraph 2-5 for details of unloading, unpacking and reprocessing of the field range outfit prior
Section IV. PREVENTIVE MAINTENANCE CHECKS AND SERVICES
a. This section contains information relative to organizational maintenance personnel in keeping the
field range in a constant state of readiness. This is accomplished by performing preventive maintenance
checks and services quarterly or every 250 hours of operation, whichever occurs first.
b. Table 4-1 contains a list of preventive maintenance checks and services which must be performed by
organizational maintenance personnel.
(1) Item Number Column. Item numbers in the first column indicate the order in which things are to
be done. The number in the item number column is used in the TM Number column on DA Form 2404,
Equipment Inspection and Maintenance Worksheet, in recording results of PMCS.
(2) Item To Be Inspected Column. A general description of the item to be inspected. Used by main-
tenance personnel for orientation.
(3) Procedure Column. Procedure to be performed by maintenance personnel.