TM 10-7360-201-10
2-8. ASSEMBLY AND PREPARATION FOR USE-Continued
(4) Flour Sifter. When a location is
selected for the sifter, proceed
as follows:
(a)
Be sure sifter is level.
(b)
Remove inverted feed hop- per
(1) from hold down box (2); tilt
hopper slightly so hopper
fastening bar (3) clears frame.
(c)
Turn feed hopper upright and
set it in place, fitting fastening
bar lock rods into holes
provided on frame. Fasten
hopper bolts (4).
(d)
Install cloth tube (5) between
hopper (1) and hold down box
(2), and fasten tube with two
clamps.
(e)
Remove eight thumbs- crews
(6) holding inverted sifter base
(8) to machine bed.
(f)
Raise sifter machine bed (7),
and turn base over; lower
machine bed into position on
base (8). Secure with eight
thumbscrews (6).
(g)
Use four stowed hook-type
stakes (9) to anchor sifter to
ground.
WARNING
Do not operate the generator set in an enclosed area unless
the exhaust gases are piped to the outside. Inhalation of
exhaust fumes will result in serious illness or death.
(5) Generator. When a location is selected for the generator, proceed as follows:
(a) Be sure generator set is level.
(b) If generator is located indoors, be sure to pipe the exhaust gas to the outside, keep room well ventilated,
and place generator where it receives a maximum of air. There must be at least 2 feet of space on all
sides of unit.
2-36
