TM 10-7310-239-13
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS, AND EQUIPMENT
5-1. Special Tools and Equipment
5-2. Maintenance Repair Parts
Special tools and equipment are not required for the
Repair parts and equipment are listed and illustrated in
maintenance of the oven.
the repair parts and special tools list in appendix D of
this manual.
Section II. TROUBLESHOOTING
5-3. General
Table 5-1. TROUBLESHOOTING
a. This
section
contains
troubleshooting
MALFUNCTION
information for locating and correcting most trouble
TEST OR INSPECTION
which may develop in the oven. Each malfunction for
CORRECTIVE ACTION
an individual component, unit or system followed by a
1.
INCORRECT TEMPERATURE INDICATION
list of tests or inspections which will help you to
Check thermometer pocket for bends,
determine probable causes a. corrective actions to take.
cracks or tears
You should perform the tests/inspections and corrective
Replace defective thermometer pocket
actions the order listed.
2.
EXCESSIVE ODOR FROM OVEN
b. This manual cannot list all malfunction that may
Check for defective flue assembly
occur, nor all tests or inspections and corrective actions.
Replace unserviceable flue assembly
If a malfunction is not list or is not corrected by listed
actions, notify your supervisor.
3.
DOORS WILL NOT LATCH PROPERLY
5-4. Direct Support Maintenance Troubleshooting
Check for faulty latch and hinge
brackets
Refer to table 5-1 for troubleshooting information.
Replace unserviceable components
NOTE
4.
SLIDING SHUTTERS INOPERABLE
Before you use this table, be sure you have
Check for damaged shutter, spacer or
performed all applicable operating checks.
holder
Replace defective components (para 6-
8)
Section III. GENERAL MAINTENANCE
5-5. General
5-6. General Procedures for Installing Rivets
a. Drive in drive (tubular rivets.
Components of the oven are secured with tabular or
solid-head rivets. The following paragraph lists
b. Peen solid-head rivets.
procedures for installation of rivets.
5-1
