TM 9-2330-328-14&P
SERVICE UPON RECEIPT OF MATERIAL
GENERAL
This WP provides information on the Repair Parts, Special Tools, Test Measurements and Diagnostic Equip-
ment, and Support Equipment for Organizational Maintenance of the 7 1/2 ton Containerized Kitchen Trailer,
XCK2000 and XCK2000E1.
NOTE
Personnel are listed only if the task requires more than one technician.
If personnel required is not listed, one technician can do the task.
UNPACKING AND CHECKING THE EQUIPMENT
a. Remove any metal strapping, plywood, tapes, seals, wrapping paper or any other shipping and
protective items.
WARNING
Dry-cleaning solvent (P-D-680) used to clean parts is potentially dangerous to personnel and
property. Do not use near open flame or excessive heat. Flash point of dry-cleaning solvent
is 138F (59C).
b. If any exterior parts are coated with rust preventive compound, remove it with cleaning solvent
(P-D-680).
c. Inspect the equipment for damage incurred during shipment.
d. Check the equipment against the packing slip to see if the shipment is complete. Report all
discrepancies in accordance with the instructions of DA Pam 738-750.
e. Uncage brake chambers in accordance with WP 00006 00-3.
SERVICING THE EQUIPMENT
a. Perform the preventive maintenance checks and services contained in WP.
b. Lubricate all points as shown in the Lubrication Instructions WP regardless of
interval.
c. Schedule the next preventive maintenance checks and services on DD Form 314, Preventive
Maintenance Schedule and Record.
d. Report all deficiencies on DA Form 2407 if the deficiencies appear to involve unsatisfactory
design.
e. Perform a break-in road test of 25 miles at a maximum speed of 50 miles per hour.
Change 1
