TM 10-7360-206-13
MOBILE KITCHEN TRAILER (MKT)
UNIT TROUBLESHOOTING PROCEDURES
GENERAL
Troubleshooting information for locating and correcting many of the operating troubles which may develop
in the Kitchen are listed in WP 0009, Table 1. Additional malfunctions beyond the scope of operator/ crew
are listed in Table 1 of this work package. Each malfunction for an individual component, unit, or system is
followed by a list of tests or inspections which will help you to determine probable causes and corrective
actions to take. You should perform the tests, inspections, and corrective actions in the order listed.
This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions.
If a malfunction is not listed or is not corrected by listed corrective actions, notify direct support
maintenance.
NOTE
Before you use this table, be sure you have performed all applicable
operating checks. Functional checks and visual inspection should isolate
most malfunctions or potential problems that occur with this equipment.
Table 1. Unit Troubleshooting Procedures
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Visual inspection.
Check lubrication of chain.
Roof vents binding during
Lubricate chain if required. Use
operation, levers loose or
Silicone Lube (WP 0058, Table
missing, cover loose, screen
1, Item 4 ) Replace damaged
damaged or missing.
components as authorized or
refer to Direct Support
maintenance personnel.
Functional Inspection.
Replace defective
Roof lifting jack bending during
components(s) as authorized or
operation.
refer to direct support
maintenance personnel.
Holes or tears in tentage
Visual inspection
Repair if possible using fabric
assemblies.
repair kit. If not, refer to Direct
Support maintenance
personnel.
Replace all damaged fasteners
Fasteners (velcro, snap, or rivet)
Visually check threaded fasteners
or refer to Direct Support
not holding.
to determine if broken, cracked,
maintenance personnel for rivet
stripped, loose, or rusted. Check
replacement.
to see that rivets are secure with
head in contact with member.
0010 00-1
