TM 10-7360-206-13
MOBILE KITCHEN TRAILER (MKT)
UNIT MAINTENANCE PROCEDURES
REPAIR CORNER POST ASSEMBLY
THIS SECTION COVERS:
Repair
INITIAL SETUP
Maintenance Level
Materials/Parts
Unit
Tools and Special Tools
Tool Kit, General Mechanics (WP 0055, Table 2, Item 1)
Move cabinet assembly away from corner post (1) being repaired.
Position roof lifting Jack at end of trailer where corner post (1) will be removed. Raise jack to height of roof
assembly.
Remove condiment tray (if applicable).
Remove nut, washer and bolt from roof frame assembly.
Remove nuts, washers, and bolts (2) from corner post mounting plate (3).
Release locking arm assembly (4) while holding upper tube (5) and allow upper tube to slowly slide into
corner post (1).
Remove locking arm assembly (4) by removing attaching bolt, nut, and washer (6).
Remove corner post assembly (1) from kitchen.
Slide upper tube (5) from corner post (1).
Replace defective parts or evacuate to direct support maintenance for repair. Clean and lubricate upper
tube (5) prior to replacement lAW WP 0016, use degreasing solvent and silicone lubricant.
Slide upper tube (5) into corner post (1).
Reinstall corner post assembly (1) onto kitchen.
Reinstall locking arm assembly (4) by replacing attaching bolt, nut, and washer (6).
Reinstall nuts, washers, and bolts (2) into corner post mounting plate (3).
Slowly slide upper tube (5) out of corner post (1) until locking arm assembly (4) can engage locking hole in
upper tube.
Reinstall nut, washer, and bolt into roof frame assembly.
Reinstall condiment tray (if applicable).
Lower and remove roof lifting jack.
0034 00-1